SafetyTac® Installation Instructions
Installing SafetyTac® floor marking tape can be completed in six easy steps. Watch SafetyTac® Installation Video
- Clean.
Start off by sweeping the floor, ridding the surface of dirt and debris. If needed, clean floor with a mild detergent to remove any surface oils or films. - Mark.
Once the area has been cleaned, measure and mark your floor to help ensure straight lines. - Anchor.
Remove a small portion of the backing from the tape, then press down on the surface to anchor SafetyTac® to your floor. - Unroll.
Once you've anchored your tape, unroll tap to desired length. Lay tape in a straight line by following your markings. - Press.
Next, go down your SafetyTac® line, gently removing the backing and pressing down to bond tape to the floor. - Secure.
Tamp down your floor marking tape with 250lbs+ of weight to ensure tape is fixed to floor securely. This can be done using a cart, dolly, or by driving a forklift down the length of the tape.
That's it! SafetyTac® should now be installed and ready to perform. Although immediately bonded, we do recommend allowing 24 hours to fully cure before exposing to water, chemicals or heavy equipment traffic.
